'wan'에 해당되는 글 1건

  1. 2014.12.10 [CCNA] [200-120] WAN (7/63)
IT 이야기2014. 12. 10. 06:24


지난강좌 : [CCNA][200-120] HSRP, VRRP 그리고 GLBP (1/36)

지난강좌 : [CCNA][200-120] SNMP (2/36)

지난강좌 : [CCNA][200-120] NetFlow (3/36)

지난강좌 : [CCNA][200-120] Syslog(4/36)

지난강좌 : [CCNA][200-120] OSI 7 레이어 & TCP/IP 레이어 (5/36)

지난강좌 : [CCNA][200-120] 시스코 IOS (6/36)



WAN은 Wide Area Network의 약자로 도시간, 지역간 혹은 나라간의 통신을 지원하는 네트워크를 말한다. 예전에는 토큰방식이나 frame-relay같은 문제가 많았다면 요즘에는 PPP나 DSL의 문제가 많이 출제된다.

Question 1) Which PPP subprotocol negotiates authentication options?
A. NCP
B. ISDN
C. SUP
D. LCP
E. DLCI

해설) PPP는 encapsulation component, Link Control Protocol (LCP), Network Control Protocol (NCP) 세가지의 컴포넌트를 가지고 있는데 이 중에 LC는 라우터간의 연결을 설정하고 테스트하는 역할을 한다. NCP는 네트워크 레이어에서 작동하고 설정된 값들의 적용에 사용되므로 답은 D 이다.

Question 2) A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?
A. Main(config)# interface serial 0/0
Main(config-if)# ip address 172.16.1.1 255.255.255.252
Main(config-if)# no shut
B. Main(config)# interface serial 0/0
Main(config-if)# ip address 172.16.1.1 255.255.255.252
Main(config-if)# encapsulation ppp
Main(config-if)# no shut
C. Main(config)# interface serial 0/0
Main(config-if)# ip address 172.16.1.1 255.255.255.252
Main(config-if)# encapsulation frame-relay
Main(config-if)# authentication chap
Main(config-if)# no shut
D. Main(config)# interface serial 0/0
Main(config-if)#ip address 172.16.1.1 255.255.255.252
Main(config-if)#encapsulation ietf
Main(config-if)# no shut

해설) encapsulation은 HDLC, PPP, SLIP등의 방법이 있고 아이피를 설정후에 encapsulation을 설정해 주므로 이기종간의 통신이 가능한 B가 답이다.

Question 3) Which two options are valid WAN connectivity methods? (Choose two)
A. PPP
B. WAP
C. DSL
D. L2TPv3
E. Ethernet

해설) WAN 구간에서의 통신방법은 PPP, DSL HDLC, MPLS, ATM 그리고 Frame Relay의 방법이 있다.

Question 4) Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in security mechanisms?
A. HDLC
B. PPP
C. X.25
D. Frame Relay

해설) 동기식(synchronous)과 비동기식(asynchoronous) 방식을 지원하는 B가 답이다.

Question 5) Which command is used to enable CHAP authentication with PAP as the fallback method on a serial interface?
A. (config-if)# authentication ppp chap fallback ppp
B. (config-if)# authentication ppp chap pap
C. (config-if)# ppp authentication chap pap
D. (config-if)# ppp authentication chap fallback ppp

해설) 답은 C이고 그냥 외워야할 문제다. 실제 설정할때에는 양쪽 라우터 모두에서 같은 인증방식이 사용해야 됨을 잊지 말자.

Question 6) Which of the following describes the roles of devices in a WAN? (Choose three.)
A. A CSU/DSU terminates a digital local loop
B. A modem terminates a digital local loop
C. A CSU/DSU terminates an analog local loop
D. A modem terminates an analog local loop
E. A router is commonly considered a DTE device
F. A router is commonly considered a DCE device

해설) CSU/DSU 는 Channel Service Unit/Data Service Unit로 Data Terminal Equipment (DTE)장비로 연결을 위한 디지탈 디바이스이다. 딱히 설명을 할 수 없고 그냥 열심히 외우자.

Question 7) Which two statements about using the CHAP authentication mechanism in a PPP link are true? (Choose two)
A. CHAP uses a two-way handshake.
B. CHAP uses a three-way handshake.
C. CHAP authentication periodically occurs after link establishment.
D. CHAP authentication passwords are sent in plaintext.
E. CHAP authentication is performed only upon link establishment.
F. CHAP has no protection from playback attacks.

해설) Challenge-Handshare Authentication Protocol의 약자로 사용자나 네트워크에 대한 권한설정을 담당한다. three-way handshake를 통해 세션을 맺고 해당 새션을 주기적으로 확인한다.


Posted by 구텐모르겐